Second, oxytocin production. Under normal circumstances, such measures as inflating, increasing the amount of water exchange, adjusting the breeding density, and providing high-quality bait, etc., can be used for the spontaneous production of the parents. Subjects can be injected LRH-A at one time, 10 micrograms/50 grams body weight for females, and 15 to 25 micrograms/tail for males. The male and females were given intrapleural injections 24 hours earlier than females. When injected, the depth should not exceed 0.5 cm and the injection volume should not exceed 1 ml. After injecting into the concrete tank or cage, raise the depth of water by 20-30 centimeters. Change the water once a day. The water temperature is 25Â°C. After 36 hours, touch the female's abdomen and feel that the eggs are free. insemination.
Third, artificial insemination. (1) Intimate choice. Females are selected to be about 30 cm in length and 150-250 g in body weight. Mature females have a spindle-shaped enlargement of the abdomen. Individuals with smaller mature females have a transparent zone on the abdomen. Egg outlines are visible outside the body and are touched by hand. The abdomen feels soft and elastic, and the genital hole is red and swollen. The males weighed 200-250 grams, the abdomen was small, there were bloodline markings on the ventral surface, and the genital pores were red and swollen. (2) Operational points for artificial insemination. Remove the female ovulation that begins to ovulate, hold the front with a dry towel on one hand, and squeeze the abdomen with the other hand from front to back. However, most clogs have cloacal blockages. At this time, small scissors can be used to cut in 0.5-1 cm at the cloaca, and then the eggs can be extruded for 3-5 consecutive times. Glass containers or porcelain pots can be used for ovulation containers. Immediately kill the male foal and take out the mature testis. Cut the testis with scissors and put it into the egg-squeezing container. Stir thoroughly. Then add 200 ml of Renji solution for 5 minutes. Add clean water to filter the testis and bloodstain. , Incubation into the incubator in still water.
Fourth, temperature control incubation. The depth of incubation is about 10 centimeters. It is advisable to constantly change the water midway, but the temperature difference should not exceed 4Â°C. Embryonic oxygen consumption is different at different stages. The more oxygen consumed in the first stage, the more aerators should be used for proper oxygenation. The time required for incubation is closely related to the water temperature. For example, at 288 hours at 22Â°C, only 26 hours at 26Â°C. It takes 134 hours and it is even shorter when the water temperature reaches 30Â°C.
Fifth, seedling cultivation. It is advisable to use a concrete tank with a depth of 30-40 cm. The upper edge should be more than 20 cm above the water surface. The bottom of the tank should be at least 20 cm thick. In the pond, a small amount of manure water is applied to cultivate silkworms, and water hyacinth and other aquatic plants rich in roots should be stocked. The fry stocking density is about 200 per square meter. The open bait is mainly silkworm, and can also be fed with zooplankton or fish sauce and egg yolk. The last part to be added is: the body length of the seedlings is only 1.1-1.2 cm when they are out of the membrane, and the yolk sac is the nutrient on the underside of the lateral pool. 5 days after the film was started, the egg yolks were fed (screened with 50 mesh). After 3 days, the rotifers were fed. After 1 week, they were fed with water silkworms and leeches. After 10 days, the fish larvae were fed and the body length was 20-25 days after emergence. 5 centimeters, began to put artificial feed, and feeding mash. After 2 months, body length 7-10 cm, can be kept in separate ponds. Seedlings are cultured for 120 days and their body length can reach 8-13 cm. There should be a certain silt layer at the bottom of the nursery pond. If there is no microfluidic condition, the water can be changed once every 2-4 days, and each time the water is changed 1/3- 1/2, temperature difference when changing water should not exceed 3 Â°C. Avoid polyculture, in order to avoid self-mutilation.
Six, disease prevention and treatment. Seedlings rarely develop, but if the environment is poor, it is prone to brucellosis, coma, etc. When the water mildew occurs, the Astragalus membranaceus can be removed by adding 3%-4% saline to the bath for 3-4 minutes. During the high temperature season, shading can be used to cool down and change the pool water to prevent coma.
In agriculture, Estrous Synchronization is used (particularly in the dairy and beef industries) to facilitate breeding by artificial insemination. We have Progesterone Injection, Cloprostenol Sodium Injection and Testerone Propionate Injection and Estradiol Benzoate to solve farmers' different difficultites in aninal 's estrous synchronization.
Estrus Synchronization Medicine,Chorionic Gonadotropin for Animals,Estrous Synchronization,Estrus Synchronization for Vet
Jiangxi Institute of Biological Products Inc. , http://www.jxinstitute.com