Sticky plastic repair leak method Oil tanks, water tanks, tubing, water pipes caused by cracks or blisters, pores, etc., caused by small leaks, can be used adhesive glue smear in the clean damage can be.
Padded control leakage method Diesel engine oil pipe joint leakproof washer leakage, can be added on both sides of the leakproof washer a layer of double-sided smooth thin plastic mats, tightly tighten to prevent leakage.
If the paper pad is in good condition and the joint surface is clean, you can apply a layer of butter on both sides of the paper pad when pumping leaks in the bottom case of the diesel engine, the cylinder head, the gear chamber cover, and the crankcase back cover. , Tighten the bolts to prevent leakage; such as a new paper pad, put the new paper pad in diesel soak for 10 minutes, remove and wipe, wipe a layer of butter on the joint surface and then install.
Leakage of the paint film solution leaks at the seams of the oil tank, water tank, crankcase, etc. The paint sheet can be soaked in alcohol and the paint liquid can be applied to the clean joint.
When anaerobic adhesive leakage method leaks on diesel engine's vent bolts, stud bolts, etc., it can be coated with anaerobic adhesive on the threads or screw holes of the cleaned bolts. It can be quickly cured to form a thin film and fill the gaps of parts. This method is better for controlling leaks at the threads of diesel engine high pressure oil pipe joints.
Liquid Sealant Leakage Method When interface leakage and destructive leakage occur due to solid gasket defects on the diesel engine, apply a liquid sealant to the cleaned solid gasket joint surface to form a uniform, stable, continuous adhesion after curing. The strippable film gasket prevents leakage.
Size recovery glue control Leakage method Diesel engine shaft and bushings, bearings and bearing seats, valves and valve seats, self-tightening oil seals, fillers, etc., when leaking, can use size recovery glue smear in the clean parts of the wear parts of the clean, after curing The formation of wear-resistant, high mechanical strength thin film layer, and then machined to restore the part of the geometry and fitting accuracy, can solve the leakage.
High Flow Nasal Cannula(HFNC) oxygen therapy is a form of non –invasive respiratory support, which comprises an air oxygen blender, an active humidifier, a single heated circuit and a nasal cannula. It delivers adequately heated and humidified medical gas up to 10-60L/min, and is considered to have a number of physiological effects: reduction of anatomical dead space, PEEP effect, constant fraction of inspired oxygen and good humidification.
It is widely used in RICU and ICU.
HUMID BH,Hfnc For Infants,Hfnc Flow Peep,High Flow Oxygen Delivery
Shenyang RMS MEDICAL TECH CO.,LTD , https://www.medicalrms.com